66
C
HAPTER
3: G
ETTING
S
TARTED
When you apply a change to the Local Host IP Configuration menu, you might get
logged out if you are using a Telnet session. The default configuration is Baud rate:
9600, Parity; none, Data Bits:8, StopBits:1.
2
Select
[1] Ethernet Port IP Configuration
to display the Ethernet Port IP
Configuration menu, shown in Figure 36.
Figure 36
Ethernet Port IP Configuration Menu
3
Enter the following information (by selecting the appropriate options and
responding to the prompts that appear at the bottom of the screen) to enable IP
Ethernet connectors:
IP Address
—Provided by the network administrator. This is the IP address of the
PathBuilder S600 Management CPU.
You should consult the network administrator to obtain an IP address for the
PathBuilder S600 which will allow its 10BaseT Management port to co-exist with
hosts on its local LAN.
Subnet Mask
—Provided by the network administrator. The subnet mask
identifies the subnetwork containing the PathBuilder S600 Ethernet management
port.
Community Name
—Enter “
3Com”
(The community name applies to Ethernet
port IP configuration only.)
Figure 37 shows a sample PathBuilder S600 IP host setup.
Summary of Contents for 3C63100-AC-C - PathBuilder S600...
