70
C
HAPTER
3: G
ETTING
S
TARTED
Figure 41
Default Gateway Configuration Menu
3
Select
[3] Previous Menu
to return to the Manage IP Network Configuration menu.
4
Select
[4] Previous Menu
to return to the System Administration menu.
Configuring In-band
Management
In addition to managing the PathBuilder S600 out-of-band, you can also manage
the unit in-band in one of the following ways:
n
via the 10Base-T port on the near-end MCPU card (up to four VCs maximum)
n
via the near-end Dual Ethernet module
For detailed instructions on configuring PVCs, see “Configuring Virtual Circuits” in
Chapter 5.
In-band Management via the 10Base-T Port on the Near-end MCPU Card
To configure in-band management via the 10Base-T port on the near-end MCPU
card, follow these steps:
If you use this method, you must use a new subnet with each PathBuilder S600
and a new static route for each new subnet on the management station or router.
You are also limited to managing up to four remote units from the central
management unit,
1
Build a PVC on the near-end PathBuilder S600 from the MCPU to the OC3 UNI
(slot 1 to slot 3), setting the following parameters on the Add Virtual Circuit
screen:
traffic shaper
—Choose any of the available values (for example, 10Mbps).
IP address
—This address must be different than the local host IP address.
subnet mask
—Specify any acceptable address (for example, 255.255.255.0).
VPI/VCI
—Enter any values in the accepted range (for example, 10/100).
Summary of Contents for 3C63100-AC-C - PathBuilder S600...
