x
C
HAPTER
: W
ARNING
I
NFORMATION
NORTH AMERICAN APPLICATIONS: Use a UL Listed and CSA Certified Cord Set
rated 12 amps, consisting of a minimum 10 AWG, Type SVT or SJT three
conductor cord maximum of 15 feet in length, with a NEMA 5-15P plug.
INTERNATIONAL APPLICATIONS: The power supply cords used with this
equipment should be harmonized with all local standards applicable in the
country in which it is installed.
Safety agency compliance requires this unit to be connected to branch circuits
with overcurrent protection
£
20A for North American applications and
£
10A
for international applications.
The power supply cord must be disconnected when servicing all components or
subsystems.
EMI
FCC
- This equipment generates, uses, and can radiate radio frequency energy,
and if not installed and used in accordance with the instruction manual, may
cause interference to radio communications. It has been tested and found to
comply with the limits for a Class A computing device pursuant with Part 15 of
the FCC Rules, which are designed to provide reasonable protection against
such interference when operated in a commercial environment. Operation of
this equipment in a residential area is likely to cause interference, in which case
the user at his own expense will be required to take whatever measures may be
required to correct the interference. These tests were conducted with shielded
communications cables with metal connector hoods; the use of unshielded
cables may void this compliance.
Canada
- This digital apparatus does not exceed the Class A limits for radio
noise emissions from digital apparatus set out in the Radio Interference
Regulations of the Canadian Department of Communications.
Europe
- This is a Class A product. In a domestic environment this product may
cause radio interference, in which case, the user may be required to take
adequate measures.
Safety Classification
of Ports for
Connection to
Telecommunications
Networks
The following port types in the product range are classified according to the
Harmonized Europeans Standard EN41003, subclause 4.1.3, as follows:
E1/E3 - TNV normally operating within SELV limits (TNV-1)
1
Telecommunications Network Voltage (EN60950, subclause 1.2.8.8)
2
Safety Extra-Low Voltage (EN60950, subclause 1.2.8.5)
Summary of Contents for 3C63400-3AC-C - PathBuilder S700 Switch
