Viewing and Configuring System Information
117
Restoring the Database
To restore the database, follow these steps:
You must have read/write access on the node to perform the restore operation.
1
Move to the directory you created earlier, in step 5 under “Backing up the
Database”. This directory should contain only the database files.
2
FTP to the node (
FTP <node>
).
n
FTP login is the node name (upper left corner of user interface)
n
FTP password is the node password (password used to access the interface)
3
Switch to binary mode by entering:
binary
4
Change directory to /fileDev/disk by entering:
cd /fileDev/disk
5
Restore all files by entering:
mput*
6
Exit FTP by entering:
bye
7
Telnet to the node.
8
Select
[1] System Administration
to display the System Administration menu.
9
Select
[12] Update Flash File System.
10
Enter
y
at the confirmation prompt to update the flash file system.
Wait for the
Update Completed
message before continuing to Step 11.
11
Select
[10] Reset Interface Card
to display the Reset Port Card screen.
12
Enter
1
, for the MCPU card.
13
Enter
y
at the confirmation prompt to reset the card.
14
Repeat steps 11-13 for each card in the shelf.
Backing up the Code Image
To back up the code image, follow these steps:
1
FTP <node>.
n
FTP login will be the node name (upper left hand corner of user interface).
n
FTP password will be the node password (the password used to access user
interface).
2
Switch to binary mode by entering:
binary
3
Change directory to /fileDev/main by entering:
cd /fileDev/main
4
Change directory to /flashDev/main (type “cd /flashDev/main”).
5
Get file image by entering:
get image bootmgmt.abs
Summary of Contents for 3C63400-3AC-C - PathBuilder S700 Switch
