118
C
HAPTER
5: C
ONFIGURING
P
ATH
B
UILDER
S700 M
ODULES
, P
ORTS
,
AND
A
PPLICATIONS
It is not necessary to rename the file image to
bootmgmt.abs
, but renaming the
file image makes the restore seem the same as a code download.
6
Exit FTP by entering:
bye
Restoring the Code Image
To restore the code image, follow these steps:
1
Move to directory that contains the bootmgmt.abs file.
2
FTP <node>.
n
FTP login will be the node name (upper left hand corner of user interface).
n
FTP password will be the node password (the password used to access user
interface).
3
Switch to binary mode by entering:
binary
4
Verify that the current directory is /flashDev/standby.
5
Put file bootmgmt.abs by entering:
put bootmgmt.abs image
6
Exit FTP by entering:
bye
7
Telnet to the node.
8
Select
[1] System Administration
to display the System Administration menu.
9
Select
[9] Switch to Standby Code
to display the Switch to Standby Code screen.
10
Enter
y
to switch to standby code.
PathBuilder S700
Configuration
Overview
Select
[2] Configuration Management
from the Main menu to display the
Configuration Management menu, shown in Figure 80. Use this menu to access
submenus and screens that allow you to:
n
Manage cards
—View shelf configuration information and configure the
PathBuilder S700 application modules.
n
Manage circuits
—List, add, modify, and delete virtual circuits.
n
Manage the bridge
—Set the bridge aging timer and configure the bridge.
n
Manage IP over ATM
—Configure and enable/disable IP over ATM for
Ethernet ports.
Summary of Contents for 3C63400-3AC-C - PathBuilder S700 Switch
