Configuring the STX Module
127
Figure 88
Input Shaper Screen
3
To enter a new shaper value, use the arrow keys on your keyboard to move to the
cell in the shaper table that you want to change.
n
To set a new
Sustainable Cell Rate
or
Peak Cell Rate
shaper, enter the new value
in the bits/second (bps) column. The system automatically calculates the
cells/second (cps) based on the value you enter.
n
To set a new
Maximum Burst Size
shaper, enter the new value in the cells
column. The system automatically calculates the bits based on the value you
enter.
How you configure the input shapers depends on the type of service you have.
n
If you have a peak rate service:
n
Set the peak rate at the maximum allowable value.
n
Set the sustained cell rate at the same rate as the peak rate.
n
If you have a sustained rate service:
n
Set the peak rate at the line rate (for example 45Mbps for a DS3 line).
n
Set the sustained cell rate and maximum burst rate at the values given to
you by your service provider.
4
When you are finished, press [ESC] to return to the MCPU Card Configuration
menu.
Configuring the STX
Module
To configure the STX module, follow these steps:
1
From the List Card menu, enter
[3] STX
to display the STX Module Configuration
menu, shown in Figure 89. This menu displays the current information for the STX
card and allows you to configure the congestion settings for up to three traffic
priority queues.
Option
[7] Set Redundancy
is disabled in Release 2.03 but will be enabled in future
releases when the PathBuilder S700 supports redundant MCPU, STX, and
application modules.
Summary of Contents for 3C63400-3AC-C - PathBuilder S700 Switch
