Configuring DS1 UNI or E1 UNI with IMA Modules
135
Configuring DS1/E1 UNI
Ports
To configure individual DS1/E1 UNI ports, follow these steps:
1
From the List Card menu, shown earlier in Figure 81, select the number
corresponding to the slot in which the DS1 UNI or E1 UNI card is installed to open
the DS1 or E1 UNI Configuration menu.
Figure 95 shows the E1 UNI Configuration menu. The DS1 UNI Configuration
menu is the same.
Figure 95
E1 UNI Configuration Menu
2
Select
[1] Port Configuration
open the DS1 UNI or E1 UNI Port Configuration
selection menu. Figure 96 shows a E1 UNI Port Configuration selection menu. The
DS1 UNI menu is the same.
Figure 96
E1 UNI Port Configuration Selection Menu
3
Select the number corresponding to the DS1 or E1 port you want to configure to
open the DS1 UNI or E1 UNI Port Configuration menu.
Summary of Contents for 3C63400-3AC-C - PathBuilder S700 Switch
