164
C
HAPTER
5: C
ONFIGURING
P
ATH
B
UILDER
S700 M
ODULES
, P
ORTS
,
AND
A
PPLICATIONS
4
Specify a new virtual circuit to pass the IP traffic over the ATM network (if desired).
a
From the Specify Virtual Circuit menu, shown earlier in Figure 128, press [s] to
display a screen similar to the one shown in Figure 129. This screen lists the
existing virtual circuits connected to the selected Ethernet port.
Figure 129
Specify Virtual Circuit Selection Screen
b
Enter the number corresponding to the virtual circuit you want to use to pass
the IP traffic over the ATM network. The circuit you select will now be listed on
the Specify Virtual Circuit menu.
5
Configure the parameters for the LAN and ATM routers that will pass the IP traffic
across the ATM network.
a
Select
[5] Configure LAN Router
to display the IP over ATM LAN Router
Configuration menu, shown in Figure 130.
Figure 130
IP over ATM LAN Router Configuration Menu
Summary of Contents for 3C63400-3AC-C - PathBuilder S700 Switch
