Performing Initial Configuration
65
Community Name
—Enter “
3Com”
(The community name applies to Ethernet
port IP configuration only.)
Figure 38 shows a sample PathBuilder S700 IP host setup.
Figure 38
Sample PathBuilder S700 IP Host Setup
4
Select
[4] Previous Menu
to return to the Local Host IP Configuration menu.
5
Select
[3] Apply IP Configuration Changes
to activate the IP address. The following
prompt appears:
This action will terminate all running TELNET/SNMP sessions.
Are you sure you want to apply IP configuration changes (Y/N)[N]?
6
Enter
y
to apply your changes.
To enter configure the SLIP management port, follow these steps:
1
From the Manage IP Network Configuration menu, select
[1] Local Host IP
Configuration
to display the Local Host IP Configuration menu, shown earlier in
Figure 36.
When you apply a change to this menu, you might get logged out if you are using
a Telnet session. The default configuration is: Baud Rate, 9600; Parity, none; Data
Bits, 8, and Stop Bits, 1.
2
Select
[2] SLIP Port IP Configuration
to display the SLIP Port IP Configuration menu,
shown in Figure 39.
192.73.30.99
192.73.30.100
3Com
Community
PathBuilder
S700
PathBuilder S700
Summary of Contents for 3C63400-3AC-C - PathBuilder S700 Switch
