70
C
HAPTER
3: G
ETTING
S
TARTED
In-band Management via the Near-end Dual Ethernet Module
To configure in-band management via the near-end PathBuilder S700 Dual
Ethernet module, follow these steps:
If you use this method, you can manage one PathBuilder S700 in a point-to-point
configuration or as many as 256 remote PathBuilder units (S310s, S330s, S600s,
or S700s) if all the units are connected to an ATM network service provided by a
local or large Telco organization.
1
Build a PVC on the near-end PathBuilder S700 from the Dual Ethernet Module to
the OC3 UNI, setting the following parameters on the Add Virtual Circuit screen:
traffic shaper
—Choose any of the available values (for example 17M)
VPI/VCI
—Enter any values in the accepted range (for example, 10/101).
2
Attach a hub or Ethernet NIC directly to the Dual Ethernet Module port.
3
Build a PVC on the far-end PathBuilder unit (S310, S330, S600, or S700) from the
MCPU to the OC3 UNI, setting the following parameters on the Add Virtual Circuit
screen:
traffic shaper
—Choose any of the available values (for example 17M)
IP address
—Specify any acceptable address (for example, 192.198.65.3).
subnet mask
—Specify any acceptable address (for example, 255.255.255.0).
VPI/VCI
—You must use the same values as you did for the near-end PathBuilder
S700.
4
Apply your IP configuration changes.
a
From the main menu, select
[1] System Administration
.
b
From the System Administration menu, select
[3] Manage IP Network
Configuration
.
c
From the Manage IP Network Configuration menu, select
[1] Local Host IP
Configuration
.
d
From the Local Host IP Configuration menu, select
[3] Apply IP Configuration
Changes
.
Performing Super User
Functions
The PathBuilder S700 supports a total of up to 10 logins at the following three
access levels:
Read-Only User
—Can view information and configuration settings in the
PathBuilder S700 interface, but cannot set parameters or make any changes.
Read-Write User
—Can view and set/change configuration information.
Super User
—Can view and set/change configuration information and can
perform the following super user functions:
n
Set passwords
n
Take over a read-write session
n
Erase the system database
The following subsections provide step-by-step instructions for performing these
super user functions.
Summary of Contents for 3C63400-3AC-C - PathBuilder S700 Switch
