Running in Server Failover Mode
95
Start the EMS server on the second machine.
Assuming it can open a
connection to your Active server this EMS server assumes it is the
Dormant server and displays the message:
------------- DORMANT SERVER MODE ---------------
--- EMS Clients cannot connect to this server ---
------------------------------------------------
These messages indicate Server Failover is running correctly.
When you login to EMS using the GUI Client you can verify the Server
Failover setup by looking at the Server Failover tab. This tab is
populated with the EMS Server states and other Server Failover
information.
Figure 21
shows the Server Failover tab and its contents.
Figure 21
Server Failover Tab
The Server Failover table in the database is used by both EMS Servers to
ensure that only one server is writing to the database. The Server Failover
Summary of Contents for 3CR15600 - Enterprise Management Suite
