230
A
PPENDIX
B: D
EVICE
S
PECIFICATIONS
AND
F
EATURES
Electrical
Switch Features
This section describes the device features. The system supports the
following features:
Line Frequency
50/60 Hz
Input Voltage
100–240 Vac (auto range)
Current Rating
2.0 Amp (Max)
Maximum Power
Consumption
200.3 BTU/hr (88 Watts)
Max Heat Dissipation
200.3 BTU/hr
Table 13
Features of the OfficeConnect Managed Fast Ethernet PoE Switch
Feature
Description
Auto Negotiation
The purpose of auto negotiation is to allow a device to advertise modes of
operation. The auto negotiation function provides the means to exchange
information between two devices that share a point-to-point link
segment, and to automatically configure both devices to take maximum
advantage of their abilities.
Auto negotiation is performed totally within the physical layers during link
initiation, without any additional overhead to either the MAC or higher
protocol layers. Auto negotiation allows the ports to do the following:
■
Advertise their abilities
■
Acknowledge receipt and understanding of the common modes of
operation that both devices share
■
Reject the use of operational modes that are not shared by both
devices
■
Configure each port for the highest-level operational mode that both
ports can support
Automatic MAC Addresses Aging
MAC addresses from which no traffic is received for a given period are
aged out. This prevents the Bridging Table from overflowing.
Back Pressure
On half duplex links, the receiver may employ back pressure (i.e. occupy
the link so it is unavailable for additional traffic), to temporarily prevent
the sender from transmitting additional traffic. This is used to prevent
buffer overflows.
Address Resolution Protocol (ARP)
ARP converts between IP addresses and MAC (i.e., hardware) addresses.
ARP is used to locate the MAC address corresponding to a given IP
address.
Class Of Service (CoS)
Provide traffic belonging to a group preferential service (in terms of
allocation of system resources), possibly at the expense of other traffic.
Command Line Interface
The Command Line Interface (CLI) is an interface using a serial connection
that allows the switch to be configured.
Summary of Contents for 3CRDSF9PWR-US - OfficeConnect Managed Fast Ethernet PoE...
