210
C
HAPTER
10: C
ONFIGURING
M
ULITCAST
F
ORWARDING
To enable Multicast Filtering:
1
Click
Policy > Multicast > Multicast Group > Setup Group
. The
Multicast Group Setup Page
opens:
Figure 108
Multicast Group Setup Page
The
Multicast Group Setup Page
contains the following information:
■
Enables Bridge Multicast Filtering
— Indicate if bridge Multicast
filtering is enabled on the device. The possible field values are:
■
Enabled
— Enables Multicast filtering on the device.
■
Disabled
— Disables Multicast filtering on the device. If Multicast
filtering is disabled, Multicast frames are flooded to all ports in the
relevant VLAN. Disabled is the default value.
■
VLAN ID
— Identifies a VLAN and contains information about the
Multicast group address.
■
Bridge Multicast IP Address
— Identifies the Multicast group IP
address.
■
Bridge Multicast MAC Address
— Identifies the Multicast group
MAC address.
2
Define the fields.
3
Click
. The Multicast group is defined, and the device is updated.
Summary of Contents for 3CRUS2475 24
