Modifying Rapid Spanning Tree Settings
229
Modifying Rapid
Spanning Tree
Settings
To modify Rapid STP:
1
Click
Policy > Spanning Tree > Rapid STP > Modify
. The
RSTP
Summary Page
opens:
Figure 118
Rapid STP Modify Page
The
Rapid STP Modify Page
contains the following fields:
■
Interface
— Displays the port or LAG on which Rapid STP is enabled.
■
Role
— Displays the port role assigned by the STP algorithm to
provide to STP paths. The possible field values are:
■
Root
— Provides the lowest cost path to forward packets to the
root switch.
■
Designated
— The port or LAG through which the designated
switch is attached to the LAN.
■
Alternate
— Provides an alternate path to the root switch from the
root interface. .
■
Backup
— Provides a backup path to the designated port path
toward the Spanning Tree leaves. Backup ports occur only when
Summary of Contents for 3CRUS2475 24
