28
U
SING
THE
P
RE
-IP C
ONFIGURATION
W
IZARD
You can only configure devices that are on the same subnet as your computer. To
configure a device on a different subnet, you must first assign it an IP address on the
same subnet as your computer. After you launch the configuration, you can change
settings as usual. Just before you finish, you must change the device IP address back to
its original setting. Follow this procedure:
1
In the Wireless Infrastructure Device Pre-IP Configuration window, accept the
suggested settings or change them as required. You can assign a static IP address
or specify that the device obtain its IP address from a DHCP server.
2
The next window prompts for an administrative password. When the units are
shipped from the factory, there is no administration password and you should
leave the password field blank. If an administration password has been set for the
device, enter the password and click
Next
. The Configuration Management System
main page appears in the Web browser.
C
ONFIGURATION
L
OGIN
After you launch the configuration from the device manager, the login page appears in
your browser. The default Username is admin and the default password is no
password. For an initial configuration, enter the default Username and click
LOGIN.
Then set the Country Code as described below.
S
ETTING
THE
C
OUNTRY
C
ODE
The Country Code determines the available channels and transmission power level
based on regulatory restrictions in the country where the access point is installed. The
first time you log in, you must set the Country Code.
To ensure compliance with local regulations, be sure to select the country in which the
access point is installed.
In the Country Code page, select the country from the pull-down list and click
Apply.
The Home page appears.
