5-40
C
HAPTER
5: C
OMMAND
L
INE
I
NTERFACE
Related Commands
sntp-server enable (5-38)
sntp-server daylight-saving
This command sets the start and end dates for daylight savings time. Use the
no
form to disable daylight savings time.
Syntax
[
no
]
sntp-server daylight-saving
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
The command sets the system clock back one hour during the specified
period.
Example
This sets daylight savings time to be used from July 1st to September 1st.
sntp-server timezone
This command sets the time zone for the access point’s internal clock.
Syntax
sntp-server timezone
<
hours>
hours
- Number of hours before/after UTC.
(Range: -12 to +12 hours)
Default Setting
-5 (BOGOTA, EASTERN, INDIANA)
Enterprise AP(config)#sntp-server daylight-saving
Enter Daylight saving from which month<1-12>: 6
and which day<1-31>: 1
Enter Daylight saving end to which month<1-12>: 9
and which day<1-31>: 1
Enterprise AP(config)#
Summary of Contents for 3CRWE876075 / WL-546
