5-51
Using the Command Line Interface
snmp-server user
This command configures the SNMP v3 users that are allowed to manage the
access point. Use the
no
form to delete an SNMP v3 user.
Syntax
snmp-server user <
user-name>
user-name
- A user-defined string for the SNMP user. (32 characters
maximum)
Default Setting
None
Command Mode
Global Configuration
Command Usage
• Up to 10 SNMPv3 users can be configured on the access point.
• The SNMP engine ID is used to compute the authentication/privacy digests
from the pass phrase. You should therefore configure the engine ID with
the
snmp-server engine-id
command before using this configuration
command.
• The access point enables SNMP v3 users to be assigned to three
pre-defined groups. Other groups cannot be defined. The available groups
are:
- RO - A read-only group using no authentication and no data encryption.
Users in this group use no security, either authentication or encryption,
in SNMP messages they send to the agent. This is the same as SNMP v1
or SNMP v2c.
- RWAuth - A read/write group using authentication, but no data
encryption. Users in this group send SNMP messages that use an MD5
key/password for authentication, but not a DES key/password for
encryption.
- RWPriv - A read/write group using authentication and data encryption.
Users in this group send SNMP messages that use an MD5 key/password
for authentication and a DES key/password for encryption. Both the
MD5 and DES key/passwords must be defined.
• The command prompts for the following information to configure an
SNMP v3 user:
-
user-name
- A user-defined string for the SNMP user. (32 characters
maximum)
Summary of Contents for 3CRWE876075 / WL-546
