5-106
C
HAPTER
5: C
OMMAND
L
INE
I
NTERFACE
Example
turbo
This command sets the access point to an enhanced proprietary modulation
mode (not regulated in IEEE 802.11a) that provides a higher data rate of up to
108 Mbps.
Syntax
turbo
<
static
|
dynamic
>
no turbo
static
- Always uses turbo mode.
dynamic
- Will use turbo mode when no other nearby access points are
detected or active.
Default Setting
Disabled
Command Mode
Interface Configuration (Wireless - 802.11a)
Command Usage
• The normal 802.11a wireless operation mode provides connections up to
54 Mbps. Turbo Mode is an enhanced mode (not regulated in IEEE
802.11a) that provides a higher data rate of up to 108 Mbps. Enabling
Turbo Mode allows the access point to provide connections up to
108 Mbps.
• In normal mode, the access point provides a channel bandwidth of
20 MHz, and supports the maximum number of channels permitted by
local regulations (e.g., 11 channels for the United States). In Turbo Mode,
the channel bandwidth is increased to 40 MHz to support the increased
data rate. However, this reduces the number of channels supported (e.g.,
5 channels for the United States).
Example
Enterprise AP(if-wireless g)#speed 6
Enterprise AP(if-wireless g)#
Enterprise AP(if-wireless a)#turbo
Enterprise AP(if-wireless a)#
Summary of Contents for 3CRWE876075 / WL-546
