130
C
HAPTER
7: IGMP S
NOOPING
Diagnosis 3:
Multicast forwarding table set up on the bottom layer is wrong.
1
Enable IGMP Snooping group in user view and then input the command
display
igmp-snooping group
to check if MAC multicast forwarding table in the bottom
layer and that created by IGMP Snooping is consistent. You may also input the
display mac vlan
command in any view to check if MAC multicast forwarding
table under vlanid in the bottom layer and that created by IGMP Snooping is
consistent.
2
If they are not consistent, refer to Technical Support for assistance.
Summary of Contents for 400 Family
