RSTP Configuration
175
You can use the following command to set the multiple value of hello time of a
specified bridge.
Perform the following configurations in System View.
Table 179
Set Timeout Factor of the Bridge
It is recommended to set 5, 6 or 7 as the value of multiple in the steady network.
By default, the multiple value of hello time of the bridge is 3.
Specifying the
Maximum Transmission
Rate of STP Packets on a
Port
The maximum transmission rate of STP packets on an Ethernet port is dependent
on the physical status of the port and the network architecture. You can specify it
as needed.
You can specify the maximum transmission rate on a port by using the following
commands.
Perform the following configuration in Ethernet Interface View.
Table 180
Specifying the Maximum Transmission Rate of STP Packets on a Por
t
Notably, though a higher transmission rate is introduced at larger
Packetnum
,
more Switch resources are consequently occupied. It is therefore recommended to
use the default value.
By default, an Ethernet port can transmit at most 3 STP packets within one Hello
Time.
Set Specified Port to be
an EdgePort
EdgePort is not connected to any Switch directly or indirectly via the connected
network.
You can use the following command to set a specified port as an EdgePort.
Perform the following configurations in Ethernet Port View.
Table 181
Set Specified Port as the EdgePort
In the process of recalculating the spanning tree, the EdgePort can transfer to the
forwarding state directly and reduce unnecessary transition time. If the current
Operation
Command
Set the multiple value of hello time of a specified bridge
stp timeout-factor
number
Restore the default multiple value of hello time
undo stp timeout-factor
Operation
Command
Specify the maximum transmission rate of STP
packets on a port
stp transmit-limit
packetnum
Restore the default transmission rate of STP
packets on a port
undo stp transmit-limit
Operation
Command
Set a specified port as an EdgePort or a non-EdgePort
stp edged-port { enable |
disable }
Set the specified port as the non-EdgePort, as defaulted
undo stp edged-port
Summary of Contents for 400 Family
