Displaying the State and Information of the System
237
■
Sending output information of the commands from the Switch you have
logged into to your terminal.
■
Supporting simultaneous configuration of multiple users.
You cannot configure the configuration agent, but can view the statistics of the
configuration agent.
Perform the following operations in all views.
Table 265
The Display Commands of the System
System Debugging
Enable/Disable the Terminal Debugging
The Switch provides various ways for debugging most of the supported protocols
and functions, which can help you diagnose and address the errors.
The following Switches can control the outputs of the debugging information:
■
Protocol debugging Switch controls the debugging output of a protocol.
■
Terminal debugging Switch controls the debugging output on a specified user
screen.
Figure 66
illustrates the relationship between two Switches.
Operation
Command
Display the system clock
display clock
Display the system version
display version
Display the saved-configuration
display saved-configuration
Display the current-configuration
display current-configuration [
controller | interface
interface-type
[
interface-number
] | configuration [
configuration
] ] [ | { begin | exclude |
include }
regular-expression
]
Display the state of the
debugging
display debugging [ interface {
interface-name
|
interface-type
interface-number
} ] [
module-name
]
Display statistics of the
configuration agent
display config-agent unit-id
unit-id
Summary of Contents for 400 Family
