Logging Function
245
2
Sending the information to the control terminal.
Table 274
Sending the Information to the Control Terminal
.
3
Sending the Information to monitor terminal
Table 275
S
ending the Information to Monitor Termina
l
4
Sending the Information to log buffer.
Device
Configuration
Default Value
Configuration Description
Switch
Enable info-center
By default, info-center
is enabled.
Other configurations are valid
only if the info-center is
enabled.
Set the information output
direction to Console
-
-
Set information source
-
You can define which
modules and information to
be sent out and the
time-stamp format of
information, and so on. You
must turn on the Switch of
the corresponding module
before defining output
debugging information.
Enable terminal display
function
-
You can view debugging
information after enabling
terminal display function
Device
Configuration
Default Value
Configuration Description
Switch
Enable info-center
By default,
info-center is
enabled.
Other configurations are valid only if
the info-center is enabled.
Set the information
output direction to
monitor
-
-
Set information
source
-
You can define which modules and
information to be sent out and the
time-stamp format of information, and
so on. You must turn on the Switch of
the corresponding module before
defining output debugging
information.
Enable the terminal
display function and
this function for the
corresponding
information
-
For Telnet terminal and dumb terminal,
to view the information, you must
enable the current terminal display
function using the
terminal
monitor
command.
Summary of Contents for 400 Family
