256
C
HAPTER
12: F
ILE
S
YSTEM
M
ANAGEMENT
Every channel has been set with a default record, whose module name is
default
and the module number is 0xffff0000. However, for different channels, the default
record may have different default settings of log, trap and debugging. When there
is no specific configuration record for a module in the channel, use the default
one.
If you want to view the debugging information of some modules on the Switch,
you must select
debugging
as the information type when configuring information
source, meantime using the
debugging
command to turn on the debugging
Switch of those modules.
You can use the following commands to configure log information, debugging
information and the time-stamp output format of trap information.
Perform the following operation in System View:
Table 303
Configuring the Output Format of Time-stamp
4
Configuring SNMP and a network management workstation on the Switch
You have to configure SNMP on the Switch and the remote workstation to ensure
that the information is correctly sent to the SNMP NM. Then you can get correct
information from the network management workstation.
Turning On/Off the Information Synchronization Switch in Fabric
After the forming of a Fabric by Switches which support XRN; the log, debugging
and trap information among the Switches is synchronous. The synchronization
process is as follows: each Switch sends its own information to other Switches in
the Fabric and meantime receives the information from others, and then the
Switch updates the local information to ensure the information synchronizes
within the Fabric.
The Switch provides a command to turn on/off the synchronization Switch in every
Switch. If the synchronization Switch of a Switch is turned off, it does not send
information to other Switches but still receives information from others.
1
Enable info-center
Perform the following operation in System View.
Table 304
Enable/Disable Info-center
2
Turn on the information synchronization Switch
Perform the following operation in System View.
Operation
Command
Configure the output format of the
time-stamp
info-center timestamp { log | trap
| debugging } { boot | date | none }
Output time-stamp is disabled
undo info-center timestamp { log |
trap | debugging }
Operation
Command
Enable info-center
info-center enable
Disable info-center
undo info-center enable
Summary of Contents for 400 Family
