Important Notices
13
The Switch 4007 software and management interfaces are built from
CoreBuilder
®
9000 switch technology. In Switch 4007 software, the
interface prompts and displays indicate this heritage. The examples,
tables, and figures in the Switch 4007 documentation may also indicate
this heritage.
CAUTION:
Except for the EME which operates four different files on
mixed release numbers (see Table 1), all modules in the Switch 4007
chassis must run software release 3.0.5 for functional reasons. The
software for CoreBuilder 9000 modules and Switch 4007 modules is
identical. Upgrade the EME first, followed by the switching modules. For
software download and installation instructions, see the chapter
“Software Installation” later in these release notes.
CAUTION:
The Switch 4007 Setup Wizard, supplied on the Software
CD-ROM, is designed to simplify installation of the switch. Release 1.0 of
the Setup Wizard enables you to enter an invalid IP address or subnet
mask, which prevents Telnet access to the EME management module.
3Com recommends that you do not use the Setup Wizard until an
updated version is available from the 3Com Web site.
CAUTION:
To run the Transcend® Network Supervisor application (for
managing and monitoring Switch 4007 activity), the Microsoft® Virtual
Machine and Microsoft WinSock2 applications may be required on your
PC. During installation, Transcend Network Supervisor will check your
PC's configuration and prompt you if these files are needed. If required,
you should exit from the Transcend Network Supervisor installation utility
and proceed to download (from the Microsoft web site) and install each
of these applications separately. After they are installed, you can restart
the installation utility for Transcend Network Supervisor.
CAUTION:
This release requires that the EME have 20 MB of CPU RAM.
To determine the current CPU RAM size, enter
show eme
from the EME
command line interface. The
CPU Ram Size (MB)
field on the left side of
the screen indicates the amount of CPU RAM:
8
or
20
. If your EME has
8 MB of CPU RAM, you must replace one of the two 4 MB DRAM cards
with a 16 MB DRAM card (order number 3CB9EE). After you install it, you
will have the required 20 MB of CPU RAM. To order a 16 MB DRAM card,
contact your network supplier or 3Com representative.
Summary of Contents for 4007
Page 10: ......
Page 32: ...32 CHAPTER 3 RELEASE ISSUES FOR MANAGEMENT MODULES...
Page 64: ...64 CHAPTER 5 RELEASE ISSUES FOR LAYER 2 SWITCHING MODULES...
Page 128: ......
