Known Problems in Release 3.0.5
81
■
There is no SNMP support for the AppleTalk Interface Count MIB
(a3ComSysAtInterfaceCount). (05994)
■
You cannot configure more than one routing interface on a
multiprotocol VLAN using SNMP. Instead, configure the routing
interface through the Web Management software or the
Administration Console.
■
You cannot delete and then successfully recreate an
hlHostControlStatus entry using SNMP.
■
IPX Policies are not shown via SNMP. (28352)
■
The SNMP object a3ComSysEthernetPortRequestedPortMode allows
you to set values that are out of range for the port. Only use the
values 10 or 100 with this SNMP object. (30022)
Ethernet
■
The
ethernet detail
display may erroneously report a flow control
value for a 10/100 port. A 10/100 port does not support flow control.
■
If a bridging loop exists on a switching module or switch fabric
module, output from the
ethernet detail
command can take up to
30 minutes to display. (30080)
Bridging
■
The STP pathcost does not reset to a lower value when you remove a
trunk. Manually reset the pathcost counter to the desired value.
■
Associated
bridge port detail
statistics do not increment when
routed frames are filtered using custom or port group filters.
■
When you connect a 10/100 Ethernet port to a 10BASE-T Ethernet
port, the system does not revise the default path cost to reflect the
10BASE-T Ethernet LAN segment. The 10BASE-T Ethernet port path
cost defaults to 100 when it should default to 10.
■
The following bridge commands may take a few minutes to complete
when several VLANs are configured in the system in allClosed mode:
■
bridge vlan mode
■
bridge vlan define
■
bridge vlan remove
■
bridge trunk define
To minimize this delay, configure VLANs in order of increasing VID and
remove them in order of decreasing VID.
Summary of Contents for 4007
Page 10: ......
Page 32: ...32 CHAPTER 3 RELEASE ISSUES FOR MANAGEMENT MODULES...
Page 64: ...64 CHAPTER 5 RELEASE ISSUES FOR LAYER 2 SWITCHING MODULES...
Page 128: ......
