167
✓
Layer 2
Switching
Modules
Multilayer
Switching
Modules
bridge link define
Defines one or more links on a Layer 2 Switching Module. When you
define a link, you specify ports and characteristics for the link.
Valid Minimum Abbreviation
b l def
Important Considerations
■
Connect the network cable to the resilient link ports after you reboot
the module; failure to do so may create a bridge loop in your network.
■
Whenever possible, create resilient links before you define your virtual
LANs (VLANs). If you plan to create resilient links for part of a VLAN,
create the resilient links before you create the VLAN. When you create
a resilient link that includes ports that are part of a VLAN, those ports
are removed from the VLAN. You must modify the VLAN and add the
new bridge port to the appropriate VLAN. This situation does not
apply to the default VLAN (all ports are part of the default VLAN).
■
If you have already defined other resilient links or trunks on your
module, you cannot select ports that are part of an existing resilient
link pair or a trunk.
■
You must reboot the module at the end of the link definition process.
(You can define multiple resilient links in one
bridge link define
operation.)
■
The resilient link port pair uses a single MAC address for frames
sourced by this pair.
■
The resilient link name can be up to 32 alphanumeric characters.
Summary of Contents for 4007
