221
bridge packetFilter
Layer 2
Switching
Modules
✓
Multilayer
Switching
Modules
portGroup addPort
Adds ports to an existing packet filter port group on a Multilayer
Switching Module.
Valid Minimum Abbreviation
b pa p a
Important Considerations
■
You add ports to an existing group by entering port identifiers at the
prompts. At least one port group must exist before you can add ports.
■
The maximum number of ports that a port group can contain is 32.
■
Possible values for port groups (
m
) depend on the number of user-
defined port groups on the module.
■
Possible values for bridge ports (
n
) depend on the number of existing
bridge ports on the module.
■
The module does not verify that ports have been added, but you can
verify it with a
bridge packetFilter portGroup display
.
Options
Prompt
Description
Possible Values
[Default]
Select port
group
Number of the port group to
which you want to add a
bridge port
■
1 –
m
■
? (for a list of
groups)
Current port
group
Select
bridge port
Number of the bridge port that
you want to add to the
selected port group
■
1 –
n
■
all
■
? (for a list of
groups)
–
Summary of Contents for 4007
