279
Layer 2
Switching
Modules
✓
Multilayer
Switching
Modules
ip rip cost
Sets the RIP cost on a per-interface basis for a Multilayer Switching
Module.
Valid Minimum Abbreviation
ip ri cos
Important Considerations
■
The default cost value is
1
, which is appropriate for most networks.
■
The module uses the cost number, between
1
and
15
,
to calculate
route metrics. Unless your network has special requirements, assign a
cost of
1
to all interfaces.
Options
Prompt
Description
Possible Values
[Default]
IP interfaces
Index number of the interfaces
for which you want to set the RIP
cost
■
One or more
selectable
interface
indexes
■
all
■
? (for a list of
selectable
interface
indexes)
Previous
entry, if
applicable
RIP cost
Selected RIP cost for the interface 1 – 15
1 (factory
default), or
current
value
Summary of Contents for 4007
