281
ip rip
routeAggregation
Layer 2
Switching
Modules
✓
Multilayer
Switching
Modules
Mode
Sets the route aggregation mode on a Multilayer Switching Module.
Valid Minimum Abbreviation
ip ri ro
Important Considerations
■
Route aggregation mode
determines which route table entries are
sent during a RIP Version 2 update.
■
If route aggregation mode is
enabled
, RIP-2 can function like RIP-1
and “collapse” route table entries for all subnets of a directly
connected network. For example, if route aggregation is
enabled
,
and the module is advertising subnets 150.100.31.0 and
150.100.32.0, only the entry for network 150.100.0.0 is sent in
the update. With RIP Version 2, you
must
enable route aggregation
mode if you want the interface to collapse the route table entries
and function like RIP-1.
■
If route aggregation mode is
disabled
(the default), a RIP-2
update sends all routing table entries.
Options
Prompt
Description
Possible Values
[Default]
IP interfaces
Index number of the interfaces
for which you want to set the
route aggregation mode
■
One or more
selectable
interface indexes
■
all
■
? (for a list of
selectable
interface indexes)
Previous
entry, if
applicable
Route
aggregation
mode
Whether you want to
implement route aggregation
on the selected interface
■
disabled
■
enabled
Current
value
Summary of Contents for 4007
