1-59
z
After sending out a RADIUS request (authentication/authorization request or accounting request)
to a RADIUS server, the switch waits for a response from the server. The maximum time that the
switch can wait for the response is called the response timeout time of RADIUS servers, and the
corresponding timer in the switch system is called the response timeout timer of RADIUS servers.
You can use the
timer response-timeout
command to set the timeout time of this timer, and if the
switch gets no answer before the response timeout timer expires, it needs to retransmit the request
to ensure that the user can obtain RADIUS service.
z
Appropriately setting the timeout time of this timer according to your network situation can improve
the performance of your system.
z
This command has the same function with the
timer
command.
Related commands:
radius scheme
,
retry
.
Examples
# Set the response timeout time in RADIUS scheme radius1 to five seconds.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] radius scheme radius1
New Radius scheme
[Sysname-radius-radius1] timer response-timeout 5
user-name-format
Syntax
user-name-format
{
with-domain
|
without-domain
}
View
RADIUS scheme view
Parameters
with-domain
: Specifies to include ISP domain names in the usernames to be sent to RADIUS server.
without-domain
: Specifies to exclude ISP domain names from the usernames to be sent to RADIUS
server.
Description
Use the
user-name-format
command to set the format of the usernames to be sent to RADIUS server
By default, except for the default RADIUS scheme "system", the usernames sent to RADIUS servers in
any RADIUS scheme carry ISP domain names.
Note that:
z
Generally, an access user is named in the
userid@isp-name
format. Here,
isp-name
behind the
@
character represents the ISP domain name, by which the device determines which ISP domain a
user belongs to. However, some old RADIUS servers cannot accept the usernames that carry ISP
domain names. In this case, it is necessary to remove domain names from usernames before
sending usernames to RADIUS server. For this reason, the
user-name-format
command is
Summary of Contents for 5500-EI PWR
