Editing the AUTOEXEC.NCF File
4-25
lec_config_mode
(LEC configuration mode)
1
, 2
1=Automatic (uses ILMI or
user-supplied LECS address)
2=Manual (must supply address for
LES or LECS when using this option)
lecs_np
(LECS network prefix)
Default is 13-byte
network portion of
ATM Forum
Well-known Address.
Use the 13-byte network prefix of the
switch on which the target LECS
resides.
lecs_up
(LECS user part)
00a03e00000100
is default
Use the 7-byte user part of the 20-byte
ATM address of the target LECS.
les _np
(LES network prefix)
26-character ASCII
string
(13 hex digits)
Use the 13-byte network prefix of the
switch on which the target LES
resides.
les_up
(LES user part)
14-character
ASCII string
(7 hex digits)
Use the 7-byte user part of the
20-byte ATM address of the target
LES.
maxvcc
(maximum number of
virtual channel circuits)
1–
1024
The default value is 1,024 VCCs. With
four NICs, the maximum number of
open VCCs is 4,096.
vpivci
(VPI/VCI range)
0
, 1, 2, 3
0=0/12 bits (default)
1=1/11 bits
2=2/10 bits
3=8/4 bits
Be sure that the VPI/VCI range is the
same for all installed NICs in the
system.
ilmi_vpi
(VPI for ILMI)
Depends on ATM
switch settings
The default value is 0.
ilmi_vci
(VCI for ILMI)
Depends on ATM
switch settings
The default value is 16.
rate
1–
155
Sets the maximum bandwidth in Mbps
available to an LEC.
sig_version
(signaling version)
0,
1
0=UNI v3.0
1=UNI v3.1 (default)
Make sure that all installed NICs in the
system use the same signaling
version.
Table 4-2
NetWare Keywords (cont’d)
Keyword
Range of Values
(Default in Bold)
Usage Rules
