LAN Emulation Redundancy
311
Make Primary LES
Active
Re-establishes the primary LES of the ELAN as the active LES. When the
secondary LES of an ELAN is active instead of the primary LES, this
command causes LECs to be released from the secondary LES to join the
primary LES. Specify the ELAN name of the primary LES.
A secondary LES becomes the active LES on the failure of the primary LES
and it remains active even when the primary LES recovers. For more
information, see “Failure Recovery - Transferring Control to the
Redundant LES” on page 158 in the Operations Guide.
You need to perform this command on all CoreBuilder 7000 switches
with active LECS and verify the result.
Command Actions
Command Result
Example
Enter:
2 1 5 9 3 elan73_9
The following message appears:
Elan was set to primary.
The primary LES of the specified ELAN becomes the active LES
.
Enter menu sequence:
(2) LEM: LAN Emulation
(1) LCS: LE Configuration Services
(5) LNT: LECS Network topology
(9) RDN: LE Service redundancy
(3) FEP: Force Elan to Primary
Enter a parameter at the prompt
Parameter
Format or Range
ELAN name
Up to 32 alphanumeric characters (see
“Display
ELANs” on page 290 in the Operations Guide
)
Direct access sequence:
2 1 5 9 3
[parameters]
System action taken:
The primary LES of the specified ELAN becomes the
active LES.
System message display:
Elan was set to primary.
Summary of Contents for CoreBuilder 7000
