Setting Up for Management
73
Update NMS Address
Enter the new NMS address to update the NMS address of the
CoreBuilder 7000 family ATM switch. The default factory NMS address is
0.0.0.0. The address is updated after the next reboot of the switch.
Command Actions
Command Result
Example
Enter:
1 1 2 2 2 100.1.0.131
The NMS address is updated to 100.1.0.131.
Enter the menu sequence:
(1) SYS: Platform config
(1) SET: Switch setup
(2) MNG: Management setup
(2) NMS: NMS Setup
(2) SNS: Set & Save NMS Address
Enter a parameter at the prompt
Parameter
Format or Range
NMS address
valid IP address
Direct access sequence:
1 1 2 2 2
[parameters]
System action taken:
The NMS address is updated after the next reboot of
the switch.
System message display:
NMS address was successfully set.
Summary of Contents for CoreBuilder 7000
