10
Inserting the Transceiver
Before you connect the system to the Gigabit Ethernet network, first
insert the transceiver into the GBIC port on the system, as described in
this section. The procedure is similar for all supported units with a
GBIC port.
To ensure optimal performance, compatibility, and regulatory
compliance, use only GBIC transceivers that 3Com supports. For a list
of GBIC devices that are qualified for the 3Com products see this
3Com Web site:
http://www.3com.com/gigabit_ethernet/gbics
CAUTION:
GBIC transceivers are keyed and can be properly inserted
only one way. If the transceiver does not click when you insert it,
remove it, turn it over, and reinsert it.
1
Read and follow the instructions in “Safety Precautions” earlier in
this guide.
2
Orient the transceiver so that the duplex SC or RJ-45 connector is
toward you.
Figure 2 shows how to insert the transceiver into a GBIC port.
Installation into other chassis is the same except that the chassis
ports may be oriented vertically.
3
Gently slide the transceiver into the GBIC port until it clicks into
place.
GBICP2_2march03.fm Page 10 Wednesday, March 12, 2003 2:35 PM
