Booting from Diskette
3-5
8
Insert a blank 2 MB (high-density) diskette (1.44 MB formatted). (Make sure
that the diskette is not write-protected.)
9
Type
2
or press the Return key to begin the format.
The server formats your diskette. When it finishes, this prompt appears:
Format another diskette (y/n):
To format another diskette, type
y
. To continue with the copy procedure,
type
n
. The following prompt appears:
Insert master and hit return to continue
10
Insert the master (source) diskette (the diskette you want to copy from) and
press the Return key.
The server copies files from the master diskette. This message appears:
Reading...OK
Insert copy and hit return to continue
11
Remove the master diskette.
12
Insert the formatted copy (destination) diskette (the diskette you are
copying to) into the diskette drive and press the Return key.
A message similar to the following appears during and after copying:
Writing...verifying...OK
Copy another disk? (y/n):
If you want to copy another diskette, type
y
. If you do not want to copy
another diskette, type
n
.
13
When the copy procedure is completed, remove the newly created diskette
and label it with the software version.
Store the original diskette in a safe place, and use a newly created diskette
as your working diskette. Make sure the working diskette is not write-
protected.
Once you have copied your diskettes, you are ready to start the server. Refer
to “Booting the Communications Server”for the procedure.
CS3000BookFile Page 5 Tuesday, October 15, 1996 5:12 PM
