Changing Configuration Settings
91
If you are using a PC that supports Plug and Play, the IRQ
and I/O base address values are set by Plug and Play. You
can set the boot PROM size to indicate the presence and
size of a network boot PROM. For instructions on disabling
Plug and Play, see “
Disabling Plug and Play on the NIC
” on
page 41
.
Follow these steps to change the configuration settings:
1 Run the installation program described in
“
Configuring the NIC
” on
page 85
.
2 From the main menu (see
Figure 58
on
page 82
),
select
Configuration and Diagnostic Program
.
3 If multiple NICs are installed in the PC, use the arrow
keys to select the NIC you want to configure. Press
Tab to move to the
Select
button and press Enter.
4 Press Tab to display the dialog box, and then select
the option that you want to change. Press Enter.
5 Use the arrow keys to scroll through the list of
settings for that option. Select a setting and
press Enter.
6 Continue this procedure for other options. For more
information on a specific option, select the option
and press F1.
7 To save the new settings, select
OK
and press Enter.
Book Page 91 Monday, June 7, 1999 8:55 AM
