Installation and Configuration Instructions
49
c
Save parameters and load the driver
2 Repeat the process for all NICs to be set up.
3 After all NICs are set up, press Esc several times to
return to the Installation Options screen.
Install Server Features
Two drivers are associated with Dynamic
Access
technology
server features under NetWare: SE and LBRSL.
1 From the Configuration Options screen select
Product options.
2 Select Install a product not listed.
The following message appears:
3 Press F3.
4 Enter this command:
3C980C_TXM:\nwserver
The following message appears:
5 Press Enter.
The system copies the Dynamic
Access
technology server
features software to the SYS volume.
Configure Groups
1 Press Esc to return to the Installation Options screen.
2 From the Configuration Options screen, select
NCF files options (create/edit server startup files)
Product will be installed from A:\. If you are
installing from floppy, insert the first
diskette of the product you want to install
into the drive and verify that the path above
is correct.
Press <F3> to specify a different path;
Press <ENTER> to continue.
Product “3Com DynamicAccess Server Features”
was found. Verify that this is the product you
want to install before proceeding.
Press <ENTER> to continue.
Press <ESC> to abort installation.
