English
– 13 –
For instructions on changing other parameters in this screen, see the
EtherLink Server 10/100 PCI NIC Family User Guide
on the
3Com EtherLink
Server CD
.
Load the Driver
1 Select
Save parameters and load driver
.
The installation program loads the configured driver and then writes the
appropriate LOAD and BIND commands to the AUTOEXEC.NCF file.
The system assigns a network number.
2 Enter a network number or press Enter to select the system-assigned
number.
If no errors are encountered, the installation program asks whether you
want to select an additional network driver.
3 Select
Yes
to set up another NIC or select
No
to complete the driver
installation.
Set Up Another NIC
1 Follow the prompts for another NIC:
a
Select the driver
b
Enter the slot number
c
Save parameters and load the driver
2 Repeat step 1 for all NICs to be set up.
3 After all NICs are set up, press Esc several times to return to the
Installation Options screen.
Install Server Features
Two drivers (SE and LBRSL) are associated with Dynamic
Access
technology
server features under NetWare.
1 From the Configuration Options screen select
Product options
.
2 Select
Install a product not listed
.
The following message appears:
3 Press F 3.
Product will be installed from A:\. If you are
installing from floppy diskettes, insert the
first diskette of the product you want to install
into the drive and verify that the path above is
correct.
Press <F3> to specify a different path;
Press <ENTER> to continue.
QuickGuideMulti.book Page 13 Thursday, October 26, 2000 11:49 AM
