1-17
z
Never replace the clock module battery when the device is powered on.
z
The system time gets lost once the clock module battery is removed. You need to set the system
time again through the command line interface.
z
Use the
clock datetime time date
command in user view to set the system date and time.
z
For details about the
clock datetime
command, refer to
H3C SecPath Series Security Products
User Manual
.
LPU–NSQ1GT8C40
Ethernet interface introduction
NSQ1GT8C40 provides eight electrical interfaces (10Base-T/100Base-TX/1000Base-T) and four
Combo interfaces. A Combo interface consists of an electrical interface and an optical interface. The
default operating interface is the electrical interface.
z
For the interface speed and duplex mode of electrical interfaces and the Combo interfaces
operating in electrical interface mode, see Table 1-20.
Table 1-20
Interface speed and duplex mode of electrical interfaces
Interface speed
Duplex mode
10 Mbps auto-sensing
Half/full duplex
100 Mbps auto-sensing
Half/full duplex
1000 Mbps auto-sensing
Full duplex
The electrical interface LEDs are above the RJ-45 ports. The LEDs in triangle and inverted triangle
indicate the status of the lower and upper electrical Ethernet interfaces respectively. For the description
of the electrical interface LEDs, refer to Table 1-7.
z
The optical interface of a Combo interface supports 1000 Mbps in full duplex mode. It has an
interface LED on the right of the optical interface, indicating the status of the SFP optical interface.
For the description of the optical interface LEDs, refer to Table 1-7.
For a Combo interface, either the electrical interface or the optical interface can operate at one time.
You can use the
combo enable
{
copper
|
fiber
} command in interface view to switch between the
electrical and optical interfaces. For details about the
combo enable
{
copper
|
fiber
} command, refer
to
H3C SecPath Series Security Products
User Manual.
