Appendix A: Router Configuration
Siemens (http://www.speedstream.com)
SpeedStream 2602 – 2-Port DSL/Cable Router
SpeedStream 2623 – Wireless DSL/Cable Router
SpeedStream 2624 – Wireless DSL/Cable Router
1. Log into your router using your router IP.
2. After you are logged in, click on
Advanced Setup -> Virtual Servers
.
3. Enter the following information on the page:
Line #1:
Private
IP:
Type in the
camera’s IP address
, for example:
192.168.0.5 (Look at WebCAM’s IP Address LCD
display for the last 3 digits of the camera’s IP address)
Private Port:
80
Type: TCP
Public Port:
80
Line #2
Private
IP:
Type in the
camera’s IP address
, for example:
192.168.0.5 (Look at WebCAM’s IP Address LCD
display for the last 3 digits of the camera’s IP address)
Private Port:
9001
Type: UDP
Public Port:
9001
4. Click
Enter
to save the settings. WebCAM should now be configured to work with
your router and be accessible from the internet.
SpeedStream 2604 – 4-port DSL/Cable Router
1. Log into your router using your router IP.
2. After you are logged in, click on
Advanced Setup -> Virtual Servers
.
3. Under the Properties section, there are a few entries you’ll need to add. Check in
the checkbox for
Enable
.
4. Under the first box, next to the Enable checkbox, type in:
WebCAM Web
.
5. Under PC (Server), select your camera or the camera’s IP address from the list. If
the camera is not listed, select the link titled “My PC is not listed.”
6. Leave Protocol as
TCP
.
WebCAM - user manual
-93-
