272
C
HAPTER
3: D
EVICE
C
ONFIGURATION
Modifying an E1 Group
You may want to modify a digital line card group to change its name,
Auto Extension assignments, or other parameters. When you modify a
group, the changes affect all the Digital Line Cards assigned to that
group. To modify a digital line card group:
1
Return to the
Digital Line Cards
tab.
2
From the
Select Device Type
pull-down list, select
ISDN PRI Group List
and
click
Apply
.
3
Select the group that you want to modify.
4
Click
Modify
. Figure 102 shows the ISDN PRI
Modify Group
dialog box.
Figure 102
Modify Group Dialog Box — E1 ISDN PRI
5
Make the changes that you want to the group parameters. Table 47
describes each parameter.
Table 47
Group Parameters
Parameter
E1 ISDN PRI Options
Group Name
Enter a name to help you to identify this group in lists.
Trunk to Trunk
The
Unrestricted
setting enables and the
Restricted
setting disables the transfer of incoming calls
to another line card port. For example, you could enable Trunk to Trunk transfers if you plan to
connect a Voice Over IP (VOIP) gateway to a line card port, permit callers to use the system to
access the telephone system from a remote location, and use it to make CO calls.
Summary of Contents for NBX 100
