Powering Up the Access Point
19
Powering Up the
Access Point
To power up the Access Point:
1
Plug the power adapter into the power adapter socket located on the
back panel of the Access Point.
2
Plug the power adapter into a standard electrical wall socket.
Connecting the
Access Point
The first step for installing your Access Point is to physically connect it to a
switch or hub. See
Figure 4
.
Figure 4
Connecting the Access Point
To use your Access Point to connect to the wireless LAN to the wired LAN:
1
Insert one end of the supplied Ethernet (RJ-45 Category 5) cable into the
LAN port on the rear panel of the Access Point.
2
Insert the other end of the cable into the RJ-45 port on switch or hub.
Check that the LAN status LED lights on the Access Point.
You have now completed the hardware installation of your Access Point.
Next you need to set up your computers so that they connect to the
Access Point.
Summary of Contents for OfficeConnect 3CRWE41196
