A
BOUT
T
HIS
G
UIDE
This guide describes how to install and configure the OfficeConnect
11Mbps Wireless Access Point (3CRWE41196).
This guide is intended for use by those responsible for installing and
setting up network equipment; consequently, it assumes a basic working
knowledge of LANs (Local Area Networks).
If a release note is shipped with the OfficeConnect 11Mbps Wireless
Access Point and contains information that differs from the information
in this guide, follow the information in the release note.
Most user guides and release notes are available in Adobe Acrobat
Reader Portable Document Format (PDF) on the 3Com World Wide Web
site:
http://www.3com.com
Naming Convention
Throughout this guide, the OfficeConnect 11Mbps Wireless Access Point
is referred to as the “Access Point”.
Category 3 and Category 5 Twisted Pair Cables are referred to as Twisted
Pair Cables throughout this guide.
The PC used to configure the Access Point is referred to as the “admin
computer”. 3Com recommends that during the initial configuration that
this is connected to the same switch or hub as the Access Point.
Summary of Contents for OfficeConnect 3CRWE41196
