86
C
HAPTER
8: P
LACING
, R
ECEIVING
AND
D
ISCONNECTING
C
ALLS
Placing a Call
Manually
You can also manually place a call to an existing service provider or to a
destination that has not been previously defined as long as the remote location
provides an IP address dynamically during call setup.
Placing a Call Manually
to an Existing Service
Provider
To place a call manually to a service provider that is already configured, do the
following.
The existing service provider must be associated with your workstation in order for
you to place a manual call to it. By default all service providers are associated with
all workstations. If you are unsure, click Workstations from the main page and
then select your workstation. Make sure the service provider you want to call is
associated with your workstation.
1
From the ISDN LAN Modem home page, click the
Manual Calling
button.
The Manual Call Control window appears.
2
In the table, locate the name of the service provider to which you want to connect
and then verify that the call is not already connected to that destination by looking
under the
Status of Call
column.
3
Click
Place Call
.
A message indicates that the call is being placed. A B channel LED on the ISDN
LAN Modem front panel illuminates green when a connection is established. Once
connected you are ready to run any desired application appropriate for that
location, such as FTP to transfer files, or you may enter a different URL in your
Web browser to access the Internet.
Placing a Call Manually
to a Temporary Service
Provider
To place a call manually to a service provider that has not been previously
configured, do the following. Note that for this type of manual call, the service
provider must supply a dynamic IP address.
This call profile will remain under
TempSvcProvider
until you change the settings
of these fields.
1
From the ISDN LAN Modem’s home page, click
Manual Calling
.
The Manual Call Control window appears.
2
In the table, locate
TempSvcProvider
.
3
Click
Place Call
.
4
Enter the telephone number of the destination in the Telephone Number field.
5
Enter your User ID for the remote destination.
6
Enter your
Password for the remote destination.
7
Enter the DNS address if the remote destination does not automatically provide an
IP address. Otherwise, leave this field empty.
8
Specify how you would like the bandwidth allocated for this connection.
You can choose always to use just one B channel for this connection, always to
use two B channels for this connection (that is, always use Multilink PPP), or you
can specify that you only want the second B channel added when the first
B channel reaches the threshold. The threshold default is 60%. To change the
threshold default, refer to “Changing Data Call Parameters” in Chapter 5.
Summary of Contents for OfficeConnect Series
