Configuring the pcXset Software
9
3
Use the Configuration Wizard tabs to configure the pcXset software.
■
Welcome
— Introduction.
■
Audio
— Test the client computer’s audio controls for compatibility
with the pcXset software.
■
Mic
— Test the headset microphone’s compatibility with the pcXset
software.
■
MAC Info
— Enter the NBX system’s MAC address.
■
IP Info
— Enter the NBX system’s IP address, subnet mask, and default
gateway. The wizard can locate this information automatically.
■
NetSet
— Add the pcXset software to the Call Processor using the
NetSet utility.
■
Country
— If you want the pcXset tones and cadences and Help to
use the same regional settings as the NBX system, select the a setting
on the Country tab. To specify different regional settings for tones and
cadences and Help, enable the
Use Advanced Settings
check box and
click
Advanced
.
■
Done!
— Finish the pcXset configuration process.
The user can now start using the pcXset application, and may customize
the pcXset display and other settings at any time.
Table 1
Windows Access Buttons
Windows Configuration Type
Button
Multimedia Control Panel — Displays Multimedia properties
for your PC.
Volume Control — Allows you to set the volume for
speaking and listening using the pcXset application.
Network Control Panel — Provides information on network
devices, such as network interface card parameters,
protocols, and IP addresses.
Microsoft System Information — Displays information about
your system, such as operating system, memory, and
processors. You must specify the MAC address of your
network adapter if you manually add the pcXset client as a
new device in the NBX system.
