BGP Configuration Commands
651
■
description-line
: Description information configured, which can be described in
characters or numerals with the length not exceeding 79.
Description
Using the
peer description
command, you can configure the description information of the
peer/peer group. Using the
undo peer description
command, you can remove the
description information of the peer/peer group.
By default, description information of peers/peer group is not configured.
For the related command, see
display current-configuration
,
display bgp peer
,
and
display bgp routing-table group
.
Example
Configure the description information of the peer named group1 as beijing1.
[3Com-bgp] peer group1 description beijing1
peer ebgp-max-hop
Syntax
peer
group-name
ebgp-max-hop [
ttl
]
undo peer
group-name
ebgp-max-hop
View
BGP view
Parameter
■
group-name
: Specifies the name of peer group.
■
ttl
: Specifies the maximum hop value. The range is 1 to 255. By default, the
value is 64.
Description
Using the peer ebgp-max-hop command, you can allow establishing EBGP
connection with the peer on indirectly connected network. Using the undo peer
ebgp-max-hop command, you can cancel the existing configuration.
By default, this feature is disabled.
Example
Establish EBGP connection with the peer group "test" on the indirectly connected
network.
[3Com-bgp] peer test ebgp-max-hop
peer enable
Syntax
peer {
group-name
|
peer-address
} enable
undo peer {
group-name
|
peer-address
} enable
View
BGP unicast address family view, IPv4 multicast address family view, VPNv4 address
family view, L2VPN address family view
Summary of Contents for Router 3000 DSL Series
Page 6: ......
Page 686: ...686 CHAPTER 6 ROUTING PROTOCOL ...
Page 758: ...758 CHAPTER 7 MULTICAST COMMON CONFIGURATION COMMANDS ...
