1-6
To do…
Use the command…
Remarks
Enable logging for network
management
snmp-agent
log
{
set-operation
|
get-operation
|
all
}
Optional
Disabled by default.
z
When SNMP logging is enabled on a device, SNMP logs are output to the information center of the
device. With the output destinations of the information center set, the output destinations of SNMP
logs will be decided.
z
The severity level of SNMP logs is informational, that is, the logs are taken as general prompt
information of the device. To view SNMP logs, you need to enable the information center to output
system information with
informational
level.
z
For detailed description on system information and information center, refer to the
Information
Center Configuration
part in this manual.
Displaying SNMP
To do…
Use the command…
Remarks
Display the SNMP information
about the current device
display snmp-agent sys-info
[
contact
|
location
|
version
]*
Display SNMP packet statistics
display snmp-agent statistics
Display the engine ID of the
current device
display snmp-agent
{
local-engineid
|
remote-engineid
}
Display group information
about the device
display snmp-agent group
[
group-name
]
Display SNMP user information
display snmp-agent usm-user
[
engineid
engineid
|
username
user-name
|
group
group-name
]*
Display trap list information
display snmp-agent trap-list
Display the currently configured
community name
display snmp-agent community
[
read
|
write
]
Display the currently configured
MIB view
display snmp-agent mib-view
[
exclude
|
include
|
viewname
view-name
]
Available in any
view.
SNMP Configuration Example
SNMP Configuration Example
Network requirements
z
An NMS and Switch A (SNMP agent) are connected through the Ethernet. The IP address of the
NMS is 10.10.10.1 and that of the VLAN interface on Switch A is 10.10.10.2.
