7-4
z
To change the link type of a port from trunk to hybrid or vice versa, you must set the link type to
access first.
z
You can use the
port link-type xrn-fabric
command to configure fabric ports. For information
about this command, refer to the
XRN Fabric
module in this manual.
Assigning an Ethernet Port to a VLAN
You can assign an Ethernet port to a VLAN in Ethernet port view or VLAN view.
z
You can assign an access port to a VLAN in either Ethernet port view or VLAN view.
z
You can assign a trunk port or hybrid port to a VLAN only in Ethernet port view.
1) In Ethernet port view
Follow these steps to assign an Ethernet port to one or multiple VLANs:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter Ethernet port view
interface interface-type interface-number
—
Access port
port access vlan vlan-id
Trunk port
port trunk permit vlan
{
vlan-id-list
|
all
}
Assign the
port to one
or multiple
VLANs
Hybrid port
port hybrid vlan
vlan-id-list
{
tagged
|
untagged
}
Optional
By default, all
Ethernet ports
belong to VLAN
1.
When assigning an access or hybrid port to a VLAN, make sure the VLAN already exists.
2) In VLAN view
Follow these steps to assign one or multiple access ports to a VLAN in VLAN view:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter VLAN view
vlan
vlan-id
Required
If the specified VLAN does not exist,
this command creates the VLAN first.
