40-11
Analysis
configuration. When a DHCP relay agent
debugging and checking the information
about debugging and interface state (You can display the information by executing the corresponding
S
t
P relay agent.
e network segment with the DHCP clients is configured
on the DHCP server.
figured between the DHCP relay agent and the DHCP server.
z
Check the DHCP relay agent. Check if the correct DHCP server group is configured on the
rk segment where the DHCP client resides. Check if the IP address
of the DHCP server group is correct.
This problem may be caused by improper DHCP relay agent
operates improperly, you can locate the problem by enabling
display command.)
olu ion
z
Check if DHCP is enabled on the DHCP server and the DHC
z
Check if an address pool that is on the sam
z
Check if a reachable route is con
interface connecting the netwo
z
If the
address-check enable
command is configured on the interface connected to the DHCP
server, verify the DHCP server’s IP-to-MAC address binding entry is configured on the DHCP relay
agent; otherwise the DHCP client cannot obtain an IP address.
