z
NDP and NTDP have been enabled on the management device and member devices, and NDP-
and NTDP-related parameters have been configured.
z
A cluster is established, and you can manage the member devices through the management
device.
2) Configuration
procedure
Perform the following operations on the management device to synchronize SNMP configurations:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter cluster view
cluster
—
Create a public SNMP
community for the cluster
cluster-snmp-agent
community
{
read | write
}
community-name
[
mib-view
view-name
]
Required
Not configured by default.
Create a public SNMPv3 group
for the cluster
cluster-snmp-agent group v3
group-name
[
authentication
|
privacy
] [
read-view
read-view
] [
write-view
write-view
] [
notify-view
notify-view
]
Required
Not configured by default.
Add a public SNMPv3 user to
the group
cluster-snmp-agent
usm-user v3
username
groupname
[
authentication-mode
{
md5
|
sha
}
authpassstring
[
privacy-mode
{
des56
privpassstring
} ] ]
Required
Not configured by default.
Create or update the public MIB
view information for the cluster
cluster-snmp-agent mib-view
included
view
-
name
oid
-
tree
Required
Not configured by default.
z
Perform the above operations on the management device of the cluster.
z
Configuring the public SNMP information is equal to executing these configurations on both the
management device and the member devices (refer to the
SNMP-RMON Operation
part in this
manual), and these configurations will be saved to the configuration files of the management
device and the member devices.
z
The public SNMP configurations cannot be synchronized to the devices that are on the cluster
blacklist.
z
If a member device leaves the cluster, the public SNMP configurations will not be removed.
3) Configuration
example
# Configure the public SNMP information for the cluster on the management device, including the
following:
z
The read community name is
read_a
z
The write community name is
write_a
z
The group name is
group_a
48-20
